Bulldog Security RS79P Installation Manual - Localisation Et Réalisation
13
CONNECTING THE 9-PIN HARNESS
9-PIN HARNESS
9-PIN HARNESS
7 8 9
6
5
4
3
2
1
IMPORTANT NOTICE: This unit when first powered up must be
initialized to code in the remote transmitter.
INITIALIZATION OF THE CONTROL MODULE:
When the unit is first powered up and all the connections are completed with
the harness plugged into the control module, the parking lights on the vehicle
will begin to flash.
You must press and hold the brake pedal then press any button on the
remote until the parking lights stop flashing. Then release the brake
and the button on the remote.
This procedure must be performed if the remote is lost or the unit memory
is cleared.
At any time you may test the remote starter. If the vehicle does not start,
check the following:
1. You may have an anti-theft system. Refer to the vehicle diagrams on the
web site or the listings on pages 17-20 in the manual.
2. The hood switch wire is grounded. Make sure the hood is shut and there
is no (-) ground to the BLACK/BLUE hood switch wire.
3. There is (+) positive voltage only when the brake is pressed.
4. The control module may need cleared. Follow the clearing procedure on
page 17 then re-initialize the control module.
LOCALISATION ET RÉALISATION
DES BRANCHEMENTS
ENTRÉE AUXILIAIRE (-) BLEU
(Pour télédéverrouillage usine ou alarme de deuxième monte)
Quand vous reliez ce système à un télédéverrouillage usine, vous devez
localiser le fil de serrures de porte qui donne une tension positive quand vous
appuyez sur le bouton de verrouillage de la télécommande usine. Un relais,
pièce n
o
775, est nécessaire pour faire passer la sortie positive du circuit de
serrures de porte à une valeur négative pour le fil
BLEU
, sur le module de
commande. Si le fil de serrures du véhicule est négatif quand vous appuyez
sur le bouton de verrouillage, le relais nest pas nécessaire. Vous pouvez
relier directement le fil au fil
BLEU
du faisceau à neuf broches.
BRANCHEMENT DE LA RS82P/RS85P AU TÉLÉDÉVERROUILLAGE
USINE À LAIDE DU RELAIS N
O
775
Vous devez programmer cette fonction; voir page 35.
SORTIE DÉRIVATION DE SÉCURITÉ (-) JAUNE À FILET NOIR
Le fil
JAUNE À FILET NOIR
sert à commander, le cas échéant, un module
de dérivation de sécurité. Ce fil donne une sortie de masse chaque fois que
la télécommande de démarrage est activée. Reliez ce fil au fil
BLEU
du
module de dérivation n
o
791 ou au fil
BLANC
du module de dérivation n
o
721 ou 781.
32