Cabletron Systems SmartSTACK ELS10-27TX Supplement Manual - 1.3.9  Enable Gvrp

Introduction

1-7

1.3.8  Restricting VLANs (802.1Q Mode)

This command will allow you to specify a list of VLAN IDs that should not be 

dynamically learned by GVRP. When the management processor receives a 

GVRP packet, it checks this database to determine if the learning of this ID 

should be restricted.

For usage, refer to the VLAN Command in Chapter 2, Enhancements to LCM 

Commands.

1.3.9  Enable GVRP

GVRP can be enabled on a per port basis using the Port command.

For further information, refer to the Port Command in Chapter 2, Enhancements 

to LCM Commands.

NOTE

There is no support for GVRP with ELS10-27TX Version 1.01.00. 

GVRP will be supported in a subsequent release. 

NOTE

There is no support for GVRP with ELS10-27TX Version 1.01.00. 

GVRP will be supported in a subsequent release.