Cabletron Systems SmartSTACK ELS10-27TX Supplement Manual - 2.5.2  Route Command

2-6

Enhancements to LCM Commands

2.5.2  Route Command

A default gateway field was added to the route command to allow 

communication to a device on a subnet not configured on this switch. The 

gateway address must be for a subnet already configured on this switch. A 

VLAN ID is not necessary for the gateway as it will use the VLAN ID associated 

with the subnet address already configured.

The syntax is:

route [add | del GATEWAY-ADDR]

  [display [IPADDR]]

Refer to the VLAN Command or IP Address Command to associate a VLAN 

with an IP subnet address.