Cabletron Systems SmartSTACK ELS10-27TX Supplement Manual - 2.5 Lcm Commands

Enhancements to LCM Commands

2-5

2.5 LCM COMMANDS

The following is a list of commands that were modified for this release: 

•

Enable Command 

•

Route Command

•

Port  Command

•

Switch Command

•

Trap Control Command

•

VLAN Command

Commands are listed alphabetically in this chapter.

2.5.1  Enable Command (Address Limit)

The address limit parameter was added to the enable command. If you set a limit 

on a port, the number of end user devices that can have connectivity will be 

limited. This is done by limiting the number of MAC addresses that can be 

learned on that port.

The format is:

   enable [PORT-RANGE [RIP] [TransmitPacing] [ADDRESS_LIMIT]]

The default is “no limit” to the number of addresses that can be learned on a port. 

If you set the limit to zero, you allow unlimited access. If you enable a port 

without specifying an address limit, you remove the limit that was in effect.