Cabletron Systems SmartSTACK ELS10-27TX Supplement Manual - Chapter 7
7-1
CHAPTER 7
WORKGROUP MIB OBJECTS
7.1 OVERVIEW
You can use a Cabletron Systems Network Management System (NMS), or a
standard SNMP-based Network Management System, to manage the
SmartSTACK Ethernet ELS10-27TX. This section describes Workgroup
configuration using the Simple Network Management Protocol (SNMP).
You should have a familiarity with networking concepts and principles. In
addition, a basic understanding of SNMP is helpful. SNMP Configuration
information is shown on the following pages.
7.2 WORKGROUPS USING SNMP
The ELS10-27TX has support for the following OBJECT-IDENTIFIERs in the
enterprise specific area. There are three Read-Only Workgroup variables, and
four Read/Write Workgroup Table variables.
7.2.1 Next Number (WorkGroupNextNumber)
The next available workgroup number to be used. When creating a new
workgroup, it is recommended to read the value of the variable and use it to key
into the workgroup table.
els10-27WorkGroupNextNumber OBJECT-TYPE
SYNTAX INTEGER STRING (SIZE (1..8))
ACCESS read-only
STATUS mandatory
::= { els10-27WorkGroup 1 }
The MIB OBJECT IDENTIFIER for reading the VLANVersionNumber
is:
OID 1.3.6.1.4.1.97.9.14.1