Cabletron Systems SmartSwitch 1800 User Manual - page 222
14-6
SmartSwitch 1800 4. 0 User G uide, Rev 01
Figure 14-3 LAN IP Interface – Secondary Address Configuration
Up to 15 secondary IP addresses can be configured on a LAN interface, providing
support for multiple IP subnets on the same physical LAN segment.
To configure a secondary address, press
[A]
. The selected address will be highlighted
in reverse video. To select a different address, press a number from
1–15
, corre-
sponding to the sequence (
Seq
) number of the entry. (Pressing any valid number
higher than the highest configured number will display a new entry for the next
sequential number after the highest configured number.
When a secondary IP address (item B) is entered, default values will be displayed for
items C and D.
To delete an existing entry, press
[G]
, then
[Y]
when asked to confirm. Any entries with
higher sequence numbers will move up one to fill in the gap.
To delete a primary address (
Source IP Address
on the first screen) without
deleting the group of associated secondary addresses, do this:
1.Select one of the secondary addresses to be the new primary.
2.Delete that secondary address.
3.Reconfigure the
Source IP Address
to specify the secondary address that
was deleted.
Node Name=nod exyz
I P In terface Configuration - Screen 2
I nterface N umber: 0
S econd ary IP A ddress Con figu ration
A
B
C
D
E
F
G
Seq
Sec. I P Ad dr
N et Mas k
Bcast Ad dr
RMetric
R IP S upp ort
Del
1
10.10.10.10
55.55.55.0
10.10.10.255
0
0
Option: