Cabletron Systems SmartSwitch 1800 User Manual - page 48
3-12
SmartSwitch 1800 4. 0 User G uide, Rev 01
E
Configure IP/LLC2/BRIDGE/IPX Interfaces
A
Review IP Interfaces
– (Chapter 14) displays information on any
IP interfaces (see below) configured in the SmartSwitch.
B
Configure IP Interfaces
– (Chapter 14) specifies addressing and
operating parameters for IP interfaces (X.25, frame relay, or LAN).
C
Review
Bridge Ports
/
LLC2 Interfaces
– (Chapter 9, Chapter 16)
displays information on any bridge or LLC2 interfaces (see below)
configured in the SmartSwitch 1800.
D
Configure
Bridge Ports
/
LLC2 Interfaces
– (Chapter 9,
Chapter 16) specifies location, type, and format of any bridge or
LLC2 interfaces.
E
Review IPX Interfaces
– (Chapter 15) displays information on
any IPX interfaces (see below) configured in the SmartSwitch.
F
Configure IPX Interfaces
– (Chapter 15) identifies any IPX
interfaces. Identifies type (X.25, Ethernet, etc.) and operating
parameters.
F
Configure BSC Devices
(Chapter 10)
A
Review BSC Device Configuration
– displays information on any
BSC Interactive devices (see below) configured in the SmartSwitch.
B
Configure BSC Devices
– identifies devices using SmartSwitch
ports configured as BSC Interactive.
D
Configure Connections and Routing Paths
A
Review Subscriber IDs
– (misc. chapters) displays information on
any subscriber IDs (see below) configured in the SmartSwitch.
B
Configure Subscriber IDs
– (Chapter 8 and misc. chapters)
identifies end users of the SmartSwitch, and specifies parameters for
redirecting traffic to other ports.
C
Review Abbreviated Addresses
– (Chapter 12) displays information
on any abbreviated addresses (see below) configured in the
SmartSwitch.
D
Configure Abbreviated Addresses
– (Chapter 12) specifies short
versions of subscriber IDs that can be used in place of the full
addresses for async PAD subscribers.
E
PVC Configuration
– (Chapter 7 [
frame relay
], Chapter 8 [
X.25
],
Chapter 12 [
async
]) displays/specifies "permanent" connections
between SmartSwitch 1800 ports.
A
Review PVC Configuration
B
Configure PVCs
F
Review IP Routing
– (Chapter 14) displays information on any IP
routes (see below) configured in the SmartSwitch.
G
Configure IP Routing
– (Chapter 14) defines routes for IP traffic
through the SmartSwitch 1800.
H
Review IPX Routing
– (Chapter 15) displays information on any IPX
routes (see below) configured in the SmartSwitch.
I
Configure IPX Routing
– (Chapter 15) defines routes for IPX traffic
through the SmartSwitch.
E
Configure Frame Relay Backup Groups
– (Chapter 7) allows creation of
one or more frame relay ports/DLCIs that will act as backup(s) for a
port.
A
Review Frame Relay Backup Groups
B
Configure Frame Relay Backup Groups