Frame relay module for the smartswitch 9000 installation & setup guide t he co mp le te ne tw or kin g s olution tm.
Cablet ron system s reserves the right t o make changes i n s pecifications and other informat ion con- tained i n this document wi thout prior notice. The reader should in all cases cons ult cabletron syst ems t o determine whether any such changes have been m ade. The hardware, firm ware, and/or s...
Installing the frame relay module the frame relay module (frm) is shipped with a cable that connects the module’s rj45 lan (ethernet or token ring, depending on the model) con- nector to a lan interface, located either on an interface module in the smart- switch 9000 or external to the rack. If the ...
Installing the i/o box assemblies each of the three rlps (risc-based line processors) in the frm has two attached lics (line interface cards), shown in figure 2. Lic 1 on each rlp supports ports 0–3, and lic 2 supports ports 4–7. Each lic requires a 4-port i/o box, as well as a cable from the rlp to...
Cabling lan adapter cable connect one end of the lan cable to the rj45 connector on the frm lan card (see figure 2), and the other end to the lan interface module. Be sure to route the cable so as not to obstruct the ability of an installer to remove other modules at some future date. Rlp cables 1. ...
Figure 5 port status display 4. Now someone must configure the software from the async terminal. Records must be configured to identify the locations and operating param- eters of the frm and its ports. Configuration of these records is docu- mented in the frame relay module user guide. If you want ...
Questions? If you have questions or problems, please contact cabletron systems technical support at: phone: 603-332-9400 fax: 603-337-3075 e-mail: support@ctron.Com ins tal lat ion & setup guide 9 document number 09-48-06-001-01 t he co mp le te ne tw or kin g s olution tm.
