CalAmp Fusion User Manual - page 16
Fusion Multi-Network LTE Router PN 001-0000-602 Rev. B
| Page 10
2
GETTING STARTED
2.1 PACKAGE CONTENTS
Fusion Router
Power Cable
Mounting Bracket or Plate (depending on fixed/portable or mobile model) and hardware
Quick-Start Guide
Information Card
2.2 POWER SUPPLY CONNECTION
The Fusion router is shipped with a DC power cable used to connect the device to a DC source. The cable includes a
fuse holder. Insert the fuse in the power cable fuse holder prior to powering on the unit. The cable connections are
listed below.
Table 9 DC Power Cable Pin-out
Pin Wire Color Description
Notes
1
Red
V
IN
DC input power lead, 13.8 V nominal (10 V to 30 V range)
2
Black
Ground
Connect to power supply ground.
3
White
Ignition Sense
Standard ignition-on signal. Maximum voltage above which ignition_sense
will be detected as ignition asserted = 9.0 V;
If IGN Sense is not used, then this line must be connected to V
IN
.
4
Yellow
External Alarm Input
External alarm input (active low); can be left floating in not used.
2.3 DEVICE CONNECTIONS
Important: Before you begin configuring the Fusion router, you will need an LTE contract with a carrier and an active
SIM or UICC card for each carrier / LTE module installed in the Fusion router.
1. Unscrew two screws to remove the cover plate covering the WWAN slots and insert the SIM/UICC card into the
WWAN slot(s) as shown. Insert the first SIM into the WWAN0 slot. If you are using a dual card solution, install the
second SIM/UICC card into the WWAN1 slot. (Retain the cover plate and attaching screws to reattach the cover
plate after setup is complete.)