CalAmp Fusion User Manual - page 51
Fusion Multi-Network LTE Router PN 001-0000-602 Rev. B
| Page 45
Name
Assign a name to easily identify this account.
Mode
Mode of operation of the cell module, which is based on the LTE module type. Typically automatic, LTE with 3G
fallback, or 3G only. For B13, for example, LTE, LTE+CDMA, or CDMA may be possible selections. It is recommended
to set this to Automatic.
APN
Access Point Name provided by the carrier. Leave this blank unless a special-user (example: static IP address) SIM is
provided by the carrier.
User
Username to provide when connecting. Leave this field blank unless one is specified by the carrier.
Password
Password to provide when connecting. Leave this field blank unless one is specified by the carrier.
Authentication
Authentication method used by the carrier. Possible selections are PAP, CHAP, or Any. If your carrier specifies a
setting select the applicable authentication method; otherwise, leave this field set for Any.
3.7.3 IP SETTINGS
Parameter definitions on this page are the same as in the IP Settings tab for the ETH0, ETH1, and ETH2 pages, except
these parameters are specified by the WWAN network provider or carrier.
Figure 36 WWAN0 / WWAN1 – IP Settings