Can-Am DS250 Operator's Manual - Warning
CONTROLS/INSTRUMENTS/EQUIPMENT
vmo2006-014-055_a
HEADLIGHTS SWITCH FUNCTIONS
1. Headlights switch
2. Low beam and taillight
3. High beam and taillight
4. OFF position
Emergency Engine Stop Switch
This switch can be used to stop the en-
gine, and as an emergency control.
NOTE:
While
the
engine
can
be
stopped by turning the ignition key
to the OFF position, we recommend
the engine be stopped using the emer-
gency engine stop switch.
To stop the engine, fully release throt-
tle lever, then set the emergency en-
gine stop switch to the STOP position.
vmo2006-014-011_b
1. Emergency engine stop switch
2. RUN position
3. STOP position
Engine Start Button
To start the engine, set the emergency
engine stop switch to RUN position.
Press and hold the engine start button,
release immediately after engine is
started.
vmo2006-014-011_e
TYPICAL
1. Engine start button
2. Emergency engine stop switch (RUN
position)
NOTE:
The engine will not crank if the
emergency engine stop switch is set to
STOP position.
Override Button
This button is used to override the
reverse speed limiter system when
backing up. Press and hold the over-
ride button then push the throttle lever
gradually forward.
WARNING
Never activate the override but-
ton if the throttle lever is not fully
released as loss of control may re-
sult.
_______________
65