Can-Am DS250 Operator's Manual - 13) Horn Button
CONTROLS/INSTRUMENTS/EQUIPMENT
5. Try to turn the handlebar on both
sides to make sure it is properly
locked.
To unlock steering, simply turn the key
counterclockwise.
13) Horn Button
The horn button is located on the LH
handlebar.
To activate horn, press the button. Re-
lease immediately after horn is set off.
vmo2006-014-056_a
1. Horn button
14) Hazard Warning Switch
The hazard warning switch is located
on the LH handlebar.
When activated, it commands simulta-
neous flashing of all turn signals.
This is used when the vehicle is sta-
tionary to indicate that the vehicle is
temporarily obstructing traffic.
vmo2006-014-056_c
1. Hazard warning switch
2. OFF position
3. Hazard position
To activate:
turn the ignition switch to
ON and set the hazard warning switch
to the HAZARD position (the triangle
like symbol).
NOTE:
Once hazards lights are turned
on, the ignition switch can be turned
OFF and the key removed.
To deactivate
Ensure the ignition switch is set to ON,
then set the hazard warning switch to
the OFF position (the solid dot symbol).
NOTE:
The ignition switch must be in
the ON position to to turn on or off the
hazard warning lights.
NOTE:
Having the hazard lights on
(even with the ignition switch in OFF
position) for a long period of time with-
out the engine running will discharge
the battery.
15) Seat Latch
Located underneath the rear fender, it
allows the removal of the seat to gain
access to the service compartment.
70
______________