Can-Am DS250 Operator's Manual - Air Injection Valve
MAINTENANCE PROCEDURES
Install radiator cap. Inspect all connec-
tions for leaks and check coolant level
in the reservoir.
Install access cover.
Air Injection Valve
Air Injection Valve Filter Cleaning
vmo2006-014-066_b
LH SIDE OF ENGINE
1. Air injection valve
Disconnect hoses from air injection
valve.
Remove air injection valve from its sup-
port.
While holding one half of the valve,
turn the other half counterclockwise to
open it.
vmo2006-014-073_a
1. Filters
Pour AIR FILTER CLEANER (P/N 219
700 341) or an equivalent into a bucket.
Put filters in to soak.
While the filters soak, clean inside the
air injection valve.
Rinse filters with warm water until all
cleaning solution disappears, then let
filters dry completely.
NOTE:
If air filters are still dirty, replace
them with new ones.
When finished, properly reinstall re-
moved parts in the reverse order of
their removal.
Drive Belt
See an authorized Can-Am dealer to in-
spect and/or replace the drive belt.
CVT Cover
CVT Cover Draining
Whenever you suspect that water has
entered the CVT cover, drain the CVT
housing by removing the drain tube.
vmr2006-064-001_a
1. CVT cover drain tube
2. CVT cover
3. LH footrest
Gearbox Oil
Recommended Gearbox Oil
Use 800 ml of XPS CHAINCASE OIL
(P/N 415 129 500) or an equivalent SAE
75W 90 chaincase oil.
NOTICE
Do not use other types of
oil when servicing the gearbox.
_______________
97