D-Link DSL-504 User Manual - Hardware Installation

DSL-504 ADSL Router User’s Guide 

2 

Hardware Installation 

This section discusses the cable connections you will need to make in order to use 

the Router. The Router has four Ethernet ports, so there are many possibilities 

for your Ethernet setup. It is advisable to give careful consideration to the 

location of the Router on your network as well as its physical location. A well 

planned Ethernet layout should be flexible and allow for future expansion. 

When selecting the location for the Router, allow room to access the connections 

on the rear panel. You will want to place the Router so that you will be able to 

see the LED indicators on the front panel. Also, allow some space above the 

Router for ventilation to avoid problems with overheating. 

It may be convenient for you place the Router near the PC you intend to use for 

initial configuration of the Router. For initial configuration of the device, you may 

need convenient access to the RS-232 serial port on the rear panel. The RS-232 

serial port is intended for use with text-based console management software for 

the initial configuration and for out-of-band management of the Router. Whether 

it is necessary to use an RS-232 console manager for first time set up depends on 

how you allocate IP addresses on your network. Read Chapter 3, First Time Set 

Up to help you decide how best to use the Router on your network.  

Connect the Power 

Insert the AC Power Adapter cord into the power receptacle located on the rear 

panel of the Router and plug the adapter into a nearby power source. You should 

see the Power LED indicator light up and remain lit.  

Connect ADSL Line 

You can use the twisted-pair ADSL cable (standard telephone cable) included 

with the Router to connect to your telephone line. Plug one end of the cable into 

the ADSL port (RJ-11 receptacle) on the rear panel of the Router and insert the 

other end into the telephone wall jack. This connection provides the link between 

the Router and the ISPs network including access to the Internet. 

The Router must undergo a negotiation process to establish the terms of the 

ADSL connection. During this negotiation the Status LED will light a steady 

green, after which it will blink. If the ADSL line is disconnected, it will repeat 

this process. 

7