D-Link DSL-504 User Manual - page 14
DSL-504 ADSL Router User’s Guide
Connect Ethernet LAN to Router
The Router may be connected to any 10/100BASE-T Ethernet LAN or Ethernet
concentrating device. Connection to an Ethernet concentrating device such as a
switch or hub should use standard twisted-pair cable with RJ-45 connectors. The
4 dedicated RJ-45 ports on the Router are a crossed (MDI-X) connection ports.
Follow standard Ethernet guidelines when deciding what type of cable to use to
make this connection. Use Category 5 or better cable for 100 Mbps connections.
You should use either crossed cable or normal straight-through cable and a cross-
over adapter when connecting the Router to a normal (MDI-X) port on a switch or
hub. Use straight-through cable when connecting it to an uplink (MDI-II) port on
a hub or switch. When connecting the Router directly to a PC or server use a
straight-through cable. The Ethernet Link LED indicator corresponding to the
connected port will indicate a valid connection.
The rules governing Ethernet cable lengths apply to the LAN to Router
connection. Be sure that the cable connecting the LAN to the Router does not
exceed the 100-meter limit.
The diagram below illustrates a variety of ways you can incorporate the Router
into your Ethernet.
LAN to Router Connection
8