D-Link DSL-504 User Manual - page 42
DSL-504 ADSL Router User’s Guide
Networks attached to the Internet are assigned class types that determine the
maximum number of possible hosts per network. The previous figure illustrates
how the net and host portions of the IP address differ among the three classes.
Class A is assigned to networks that have more than 65,535 hosts; Class B is for
networks that have 256 to 65534 hosts; Class C is for networks with less than
256 hosts.
IP Network Classes
Cla
ss
Maximum
Number of
Networks
in Class
Network Addresses
(Host Portion in
Parenthesis)
Maximum
Number of
Hosts per
Network
A
126
1(.0.0.0) to 126(.0.0.0)
16,777,214
B
16,382
128.1(.0.0) to 191.254(
.0.0)
65,534
C
2,097,150 192.0.1(.0)
to
223.255.254(.0)
254
Note: All network addresses outside of these ranges (Class D and E) are either reserved or set
aside for experimental networks or multicasting.
When an IP address's host portion contains only zero(s), the address identifies a
network and not a host. No physical device may be given such an address.
The network portion must start with a value from 1 to 126 or from 128 to 223.
Any other value(s) in the network portion may be from 0 to 255, except that in
class B the network addresses 128.0.0.0 and 191.255.0.0 are reserved, and in
class C the network addresses 192.0.0.0 and 223.255.255.0 are reserved.
The value(s) in the host portion of a physical device's IP address can be in the
range of 0 through 255 as long as this portion is not all-0 or all-255. Values
outside the range of 0 to 255 can never appear in an IP address (0 to 255 is the
full range of integer values that can be expressed with eight bits).
The network portion must be the same for all the IP devices on a discrete
physical network (a single Ethernet LAN, for example, or a WAN link). The host
portion must be different for each IP device — or, to be more precise, each IP-
capable port or interface — connected directly to that network.
36