D-Link DSL-504 User Manual - About This User’S Guide
DSL-504 ADSL Router User’s Guide
About This User’s Guide
This user’s guide provides instructions on how to install the DSL-504 ADSL
Router and use it to PCs or Ethernet concentrating devices on an Ethernet LAN
(Local Area Network) to the Internet or remote LAN. For the sake of simplicity,
this document uses the terms Router (first letter upper case) to refer specifically
to the DSL-504 ADSL Router, and router (first letter lower case) to refer to all
such devices including the DSL-504.
This guide assumes that the reader is familiar with Ethernet networks,
networking devices, routing protocols and the TCP/IP suite of protocols.
Before You Start
This section discusses the various requirements for the successful installation of
the Router. In order to avoid difficulties please read and make sure you
understand all the prerequisites for proper installation and operation of your new
ADSL Router.
Operating Systems
D-Link’s web-based management software for the Router can be used with any
browser-equipped PC running Microsoft
Windows 95, Windows 98, Windows
98 SE, Windows ME, Windows 2000 and Windows NT 4.0.
ADSL Service
In order to use the Router, you must first have ADSL service established with
your local telephone company, or an Internet Service Provider (ISP). Contact
your local telephone company for information on the availability of ADSL service
in your area.
Micro-filters
Since ADSL and telephone services share the same copper wire to carry their
respective signals, a filtering mechanism must be used to avoid mutual
interference. You may need to install a micro-filter (low pass filter) device for
each telephone that shares the line with the ADSL line. Micro-filters are easy to
install in-line devices, which attaches to the telephone cable between the
telephone and wall jack. This device will not affect normal telephone services.
Your telephone company will have more information regarding the use and
installation of micro-filters.
iv