EAW KF760 Rigging Manual - page 12

KF760 Series Rigging Procedures  PRELIMINARY DRAFT -- 21 Aug 01

KF760 Series Rigging Procedures  PRELIMINARY DRAFT -- 21 Aug 01   Page 11 of 29

11.    Using  the  two  short  connecting  pins  stored  in  the  bottom  rear  of  the  bottommost  flown  enclosure,

engage the two rear hinges of the topmost  palleted enclosure in their appropriate position into the Hinge

Tubes of the flown enclosure.  Secure using a short connecting pin in each. 

12.  If Using the Pull-Back Bar (not shown):

If the Pull-Back Bar is to be used, the rear hinges on any splayed enclosures must be locked in position to

prevent the hinges from moving down into their own Hinge Tubes when the pull-back force is applied.

To lock the hinges, insert a connecting pin into the top hole of the each rear Hinge Tube and through the

bottom  of  the  hinge.  This  prevents  the  hinge  from  moving  back  down  into  its  own  Hinge  Tube  when  an

upward force is applied to the rear of the enclosure.  When enclosures are tight-packed, the hinge locking

pin is not needed.

13.  Disconnect pallet from the rear of the bottom enclosure by removing the connecting pins.  Insert the

four connecting pins in the bottom enclosure Hinge Tubes.