EAW KF760 Rigging Manual - page 21

KF760 Series Rigging Procedures  PRELIMINARY DRAFT -- 21 Aug 01

KF760 Series Rigging Procedures  PRELIMINARY DRAFT -- 21 Aug 01   Page 20 of 29

12.  Push the KF760 pallet aside and fly array to an appropriate height for the next step

13.  Repeat the above KF761 steps for any additional KF761s.

2.3.5

Pull-Back Bar If Used (not shown)

1.    Install  the  Pull-Back  Bar  by  lifting  the  Bar  and  aligning  the  Hinge  Tubes  on  the  Pull-Back  Bar  with

those on the rear of the bottommost enclosure.  Slide each of the two hinges on the Pull-Back Bar up into

the  Hinge  Tubes  on  the  bottommost  enclosure.    Pin  each  hinge  to  the  uppermost  hole  in  the  enclosure

Hinge Tube using a short connecting pin.

2.  Attach the pull-back chain motor to the hoisting ring on the Pull-back Bar.

2.3.6

Last Step

1.  Fly out the array to its trim height.  If used, adjust the height of the pull-back motor to set the overall

down angle of the array.

2.4

LOAD-OUT

2.4.1 Pull-Back Bar If Used (not shown)

1.  Drop the array to the deck with the weight on the chain motors.  Slack the Pull-back motor and detach

it from the Pull-back Bar.

2.  Detach the Pull-back bar from the bottom rear of its enclosure by disengaging the short connecting pin

at  each  end.    Reinsert  the  connecting  pins  back  in  the  holes  from  where  they  were  removed  from  the

bottom most flown enclosure.