EAW KF760 Rigging Manual - page 6

KF760 Series Rigging Procedures  PRELIMINARY DRAFT -- 21 Aug 01

KF760 Series Rigging Procedures  PRELIMINARY DRAFT -- 21 Aug 01   Page 5 of 29

1. Bring in the first pallet of four KF760s and position it under the chain motors.

2.  Lower the chain motors for attachment ot the Fly-Bar Hoist Rings.

3.  If the Fly-Bar was transported attached to palleted KF760s then attach the chain motors to the Fly-Bar

and skip the next steps.

4.    If  the  Fly-Bar  was  transported  un-attached  from  a  KF760  pallet  then  attach  the  chain  motors  to  the

assembled Fly-Bar and perform the next two steps (not shown):

1.  Land the Fly-Bar on top enclosures so the weight is off the chain motors.