EAW KF760 Rigging Manual - page 29

KF760 Series Rigging Procedures  PRELIMINARY DRAFT -- 21 Aug 01

KF760 Series Rigging Procedures  PRELIMINARY DRAFT -- 21 Aug 01   Page 28 of 29

4.    Connect  the  bottom  KF760  to  the  pallet  at  all  four  corners  by  lifting  the  hinges  on  the  pallets   Hinge

Tubes into each enclosure Hinge Tube and secure each with a connecting pin. The connecting pins for

this should have been stored in the bottom of the KF760 (see section 2.4.4 step 7).

5.    Check  for  and  remove  any  hinge  locking  pins  from  the  rear  Hinge  Tubes  and  put  aside  for  loose

storage.

2.4.6

Fly-Bar

Fly-Bar Stays with Enclosures:

1.  If not already done, lock the four hinges of the top enclosure in their fully extended (up) position.  Do

this  by  inserting  a  short  connecting  pin  into  the  topmost  holes  on  each  of  the  four  Hinge  Tubes  of  the

topmost enclosure.

2.  Bump in the chain motors so the hoist rings are  slack .  Disconnect the chain motors from the Fly-Bar.

3.  Fly out the chain motors and move the palleted KF760s aside.

4.  The loaded pallets are ready for transport.

Fly-Bar Removed from Enclosures (not shown):