EAW KF760 Rigging Manual - page 24

KF760 Series Rigging Procedures  PRELIMINARY DRAFT -- 21 Aug 01

KF760 Series Rigging Procedures  PRELIMINARY DRAFT -- 21 Aug 01   Page 23 of 29

8.  Push the palleted KF761 aside.

2.4.3

Second And Subsequent KF671s

1.  The array should already be positioned at about 4 feet / 1.2 m or enough to allow the KF761 to swing

down on its rear hinges with its face parallel to the floor and above the level of its pallet.

2.  Position an empty KF761 pallet under the array.

Not Shown:

3.  Remove any hinge locking pins from the KF761 rear Hinge Tubes and put aside for  loose  storage.

4.    While  supporting  the  front  of  the  KF761,  remove  the  connecting  pins  from  its  front  hinges.    Put  the

connecting pins back in the hole from which they were removed.  Ease the front of the KF761 down so it

is hanging from the rear hinges.