EAW KF760 Rigging Manual - page 30

KF760 Series Rigging Procedures  PRELIMINARY DRAFT -- 21 Aug 01

KF760 Series Rigging Procedures  PRELIMINARY DRAFT -- 21 Aug 01   Page 29 of 29

1.  Remove the front and rear connecting pins from the hinges between the top enclosure and the Fly-Bar

so the hinges drop into the enclosure s Hinge Tubes.

2.  Reinsert the removed connecting pins into the holes on the Fly-Bar from which they were removed.

3.  Fly out the Fly-Bar.

4.  Push the pallet loaded with the four KF760s out of the way.

5.  Lower the Fly-Bar to the deck and disconnect the chain motors from the Fly-Bar.

6.    The  Fly-bar  can  be  left  as is or dismantled for packing.  To dismantle, remove the Tail Bar (if used)

from the Spreader and remove the Spreader from the Rigging Bars.