Eberspächer EasyStart Timer Installation Instructions Manual - 11.1: Off
VEhICLE hEATERs – TEChnICAL DOCuMEnTATIOn | 13
3 sTARTup / COnFIguRATIOn
ACTIVATIng OR DEACTIVATIng AuTOMATIC
OpERATIng TIME CALCuLATIOn FOR WATER
hEATERs – ITEM 11.1:
Default: “Off”
use the
or
button to select Item
11.1: and confirm by pressing the
button.
use the
or
button to select “Off” or
“On”.
11.1: Off
SERVICE
11.1: On
SERVICE
press the
button to confirm the selection.
After confirming you must reset the system by
removing the 5 A fuse.
please nOte!
Automatic operating time calculation is not
possible for air heaters; if ITEM 11.1: is
selected the following appears in the display:
11.1: --
SERVICE
FOR AuTOMATIC OpERATIng TIME CALCu-
LATIOn, COpy ThE VEhICLE's EngInE sIzE
(CubIC CApACITy) – ITEM 11.2:
Default: 1800 cm
3
use the
or
button to select Item
11.2: and confirm by pressing the
button.
use the
or
button to enter the engine
size in 100 cm
3
increments.
setting range: 1000 cm
3
to 4000 cm
3
.
11.2: 1800
SERVICE
press the
button to confirm the setting.
please nOte!
The engine size entered can be increased by
500 cm³ for a larger heat requirement.
If the valve 25 2014 80 62 00 or 25 2014 80
72 00 is used in the water circuit, the engine
size entered can be reduced by 500 cm³.
The values for the increase or reduction in
the engine size entered are only valid for
cooling water circuit, whose vehicle fan heat
exchanger is flowed through before the vehi-
cle engine.