Eberspächer EasyStart Timer Installation Instructions Manual - page 9
VEhICLE hEATERs – TEChnICAL DOCuMEnTATIOn | 9
2 InsTALLATIOn
-xs10 / -xb10 cOnnectOr pin
assignment table
pin
signal
Cable colour
Cross-section
1
Terminal 30
red
0.35 mm²
2
Terminal 58
grey / black
0.22 mm
2
3
Terminal 31
brown
0.35 mm
2
4
Diagnosis
blue / white
0.22 mm
2
5
DAT cable
violet
0.22 mm
2
6
s+
yellow
0.35 mm
2
7
ADR
brown / yellow
0.22 mm
2
8
ADR
white / red
0.22 mm
2
9
Temp (–)
brown / white
0.22 mm
2
10
Temp (+)
grey
0.22 mm
2
cOnnectiOn Of bush hOusing tO the
cOntrOl unit lead harness
Clip the control unit lead harness into the
10-pin bush housing; note and follow the
circuit diagram.
push the contact locking device into the
bush connector housing.
Connect the bush housing of the control
unit lead harness and the connector hous-
ing of the Easystart Timer lead harness.
Insulate and tie back any cable ends that
are not needed.
install the (OptiOnal) temperature
sensOr
plug the connector of the (optional) room tem-
perature sensor lead harness into the 10-pin
bush housing of the control unit lead harness.
For connection details, see-Xs10 / -Xb10 con-
nector pin assignment table.
use the screw provided to fasten the tempera-
ture sensor inside the vehicle so that it meas-
ures the representative interior temperature.
Recommendation:
Install the temperature sensor in the centre
console, at the level of the seats.
please nOte!
Install the Easystart Timer in the vehicle
interior only.
Do not position the temperature sensor in
an area in which is exposed to direct sun-
light, near the outlet vents of the vehicle or
in the footwell.
For circuit diagrams see
from page 17
.
Do not insert the control unit 5 A fuse into
the fuse holder until all work has been
completed.