Eberspächer EasyStart Timer Installation Instructions Manual - page 4
4 | VEhICLE hEATERs – TEChnICAL DOCuMEnTATIOn
please read first
before you start to install the Easystart Timer,
always read through these installation instruc-
tions carefully.
These installation instructions contain impor-
tant information, which you need to install the
Easystart Timer.
safety instructiOns
danger!
Always note and follow all information and
notes, especially the safety instructions in
this document and in the heater's technical
description!
intended use
The Easystart Timer is used to select the
operating mode, to set the operating time,
to preselect the switching on time and to
switch On / Off the heater and / or add-on unit
installed in the vehicle.
please nOte!
Improper use and use outside the specified
purpose cancels all liability and warranty.
1 InTRODuCTIOn
general infOrmatiOn
AuTOMATIC OpERATIng TIME CALCuLATIOn
To use the AuTOMATIC OpERATIng TIME
CALCuLATIOn function of a water heater, the
optionally available temperature sensor must
be used.
For temperature sensor Order no.
see page
5
.
VentilatiOn Operating mOde
In VEnTILATIOn mode the fan of water heat-
ers is actuated directly by bypassing heating
mode. If the symbol is not displayed the
VEnTILATIOn function is not available for the
heater.
If you have any further questions about
VEnTILATIOn mode, please dial the service
telephone number
see page 19
.
InsTALLATIOn InsTRuCTIOns FOR spECIAL
FunCTIOns
These installation instructions describe
the standard configuration. For details of
enhanced configuration of the Easystart Timer
and for special functions such as combina-
tions with various Easystart control units,
installation in ADR vehicles, operating the
heater and additional unit, etc. the “special
Functions and Diagnosis” installation instruc-
tions are available to view and to download
from
www.eberspaecher-standheizung.com/down-
load.