Eberspächer EasyStart Timer Installation Instructions Manual - page 7
VEhICLE hEATERs – TEChnICAL DOCuMEnTATIOn | 7
2 InsTALLATIOn
installing the easystart timer
cautiOn!
When drilling the fixing and connection holes
in the dashboard, concealed components
behind it could be damaged.
Î
Check that the space behind the installa-
tion area is free from components.
Install the Easystart Timer in a suitable place
on the dashboard, within the driver's view and
connect as shown in the sketch on
page 8
and the circuit diagram
from page 17
.
use the self-adhesive drilling template
supplied to position and drill the two holes
ø 6.5 mm and ø 9 mm. After drilling the
holes, remove the drilling template.
The foam underlay can be used if neces-
sary to level out unevenness. To do this,
pull off the protective film and stick the
foam underlay onto the installation area.
Then pull off the second protective film.
Insert the holder with expansion plug into
the drillhole ø 6.5 mm.
Align the holder, if applicable, press the
holder firmly onto the foam underlay.
screw the fixing screw into the expansion
plug and therefore fasten the holder.
Feed the lead harness from the Easystart
Timer through the drillhole ø 9 mm.
Clip the Easystart Timer into the holder.
installing the tab cOnnectOr Of the
easystart timer lead harness
plug the tab connector (1) of the Easystart
Timer lead harness into the 10-pin con-
nector housing (For details of connector
housing pin assignment
see page 8
and
page 9
).
push the contact locking device (2) into the
connector housing.
please nOte!
When installing the connector, ensure that the
locking tangs always face the middle of the
connector. Only in this position to the tangs
latch into the housing (see sketch).