ECOVACS WINBOT Instruction Manual - page 74

ENG - 74

WARNING

If Winbot is used to clean a window above ground level, the Safety Pod MUST be used.

Winbot must be used in strict accordance with the directions in the Instruction Manual. 

ECOVACS can not be held liable or responsible for any damages or injuries caused due to 

improper use.

1)  Make sure that there is enought power cord for the WINBOT to clean the entire window 

without restricting its movement. If there is not enough cord, it is not safe to use the 

WINBOT on that particular window until a WINBOT Extension Cord is attached.

2)  Loop one end of the Safety Rope around the Safety pod´s channel and pull it tight.

3)  Loop the other end of the Safety Rope to the power connector on the power cord and 

tighten.

4)  If an Extension Cord is attached, the Safety Rope must be tied to the power connector on 

the Extension Cord. Note: Do NOT attach the Safety Rope to the thin part of the cord.

5)  Press the Safety Pod suction cup FIRMLY in the lower corner on the opposite side of the 

glass you are cleaning. Make sure the Safety Pod suction cup is securely in place.

6)  Place WINBOT on the window, close the window if cleaning the outside of the window, and 

start WINBOT.

7)  After WINBOT is done cleaning remove it from the window. Grasp the handle, switch the 

unit OFF, insert finger into Air Release Trigger and pull up on it for 20 seconds until suction 

has dimished.

Please read the entire contents of the Winbot Instruction Manual for detailed instructions.

1)  When using the product, a person should be in the vicinity to assist should 

there be a problem.

2)  Before using the product on the outside ofthe window, you must use the Safety 

Pod. Read the instructions on SAFETY POD use in your Instruction Manual.

3)  When removing the Winbot, grasp the handle ofthe unit and move the switch 

underthe handle to ‘ the left - OFF position, and while still grasping the unit, 

insert finger into the Air Release trigger and Pulling up on it, remove the unit 

from the window when the suction has diminished.

4)  Please make sure the Winbot’s back-up battery is fully charged before use.  

If you have not used the product for overa month or the product alarms (which 

consumes the back-up battery`s power) over an hour, please  recharge its 

battery.