ECOVACS WINBOT Instruction Manual - page 87
Enjoy smarter life
ENG - 87
ENG
8. MEANING OF INDICATORS
No
Sound
Light
Meaning
1
Emits Tone
N/A
Has been connected with power.
2
Emits Tone
Indicator Light Flashes Blue
Winbot finishes cleaning
3
N/A
1. Indicator Light Flashes Blue
2. Indicator Light Steady Blue
a. Winbot has first been placed
on window and has successfully
suctioned itself to the glass
b. Winbot is cleaning the window
4
Emgits double
Sound
Indicator Light Flashes Red
Please refer to Alarm & Solution
section
5
Emits double
Sound
Indicator Lights Steady Red
Product has a problem and requires
you calling and talking to our
Service Technician.
6
N/A
Indicator Light flashes Green
Back up battery is Charging
7
N/A
Indicator Light steady Green
Back up Battery is Fully Charged
9. ALARM & SOLUTIONS
Alarm Sound
Light
Causes
Solutions
Toot, toot
Red light
flashes
1. Turning Winbot ON
when not plugged
into receptace
a. Connect unit to the adapter and
Adapter into the receptacle and
the Indicator Light will turn off.
b. You must plug the Adapter back
into the receptacle.
c. 1) Remove Winbot from the win-
dow and turn the power OFF.
Turning the unit over, inspect
the gaskets for a tear or for dirt
stuck on the gasket surface.
Gently clean the surface of de-
bris to make it smooth again.
2) Check the window to make sure
there is no hard debris that would
affect the gasket on Winbot.
d. T ake the Remote in hand and
pressing one of the ARROW
buttons, move Winbot away from
the window frame.
e. The smallest window Winbot can
automatically clean is 24 inches
high by 18 inches wide.
f. The window frame thickness must
be over 5 mm.
Should these suggestions not correct
the problem, please contact our
Service Center and talk with
a Technical Representative
2. While cleaning
the window, Winbot
clening disconnected
from the Power
Source.
3. Vacuum is leaking at
the gaskets.
4. Bumper is pressed
against the window
frame and raised;
5. Window is too small
for Winbot to clean.
6. The window frame is
too thin.