ECOVACS WINBOT Instruction Manual - page 82

ENG - 82

4.2 Product Start

 •   Once the unit is attached to the outside ofthe window, press  

the Start Button on the unit or the Start/Pause button on  

the Remote. The product will use its automatic cleaning mode to 

clean the window and return to the start position after having 

cleaned the window.

NOTE:

•  This product is intended for cleaning dust on common home  

windows. Winbot can NOT be used to clean stains such as painting,  

glue, etc. Winbot can NOT be used to remove items such as 

chewing gum, label, papers, etc which may cause suction failure.

•  Glass with uneven surface, such as frosted, textured, patterned 

or leaded is not suitable to be cleaned by the Winbot.

•  After Winbot has finished cleaning one window, ifthe cleaning 

pads are too dirty, please replace them with a clean set.

•  The unit may NOT be used outside while raining, snowing or 

colderthan 40 °F as it will damage the product and could cause 

electrical problems.

•  Should the unit stop working and the Indicator Light blink RED, 

you need to respond by grasping the handle ofthe unit and turn 

the switch OFF. You may then turn the switch back ON and press 

the Pause/Start button to start the cleaning process.

4.3. Product Pause

 •   lf you want to Pause the product during the cleaning process, 

press the “ ” button on the Remote Control momentarily or 

press the “ ” button on the unit.  

The product will pause and wait for further instructions.

•  While the unit is in the Pause Mode, you may use the Remote 

to move the unit around the window by pressing the appropriate 

directional arrow. This is handy for your use when a spot on the 

window is difficult to clean, because you can maneuver the unit 

back to the spot and clean again. When you want to return the 

unit to the Auto Mode to continue cleaning, press the pause  

button on the Remote.