ECOVACS WINBOT Instruction Manual - page 83

Enjoy smarter life

ENG - 83

ENG

4.4. Product Stop

 •   After the product has finished cleaning the window, it will return 

to the place where you had started the cleaning. lfyou find 

the stopping place is not convenient for you to grasp to remove 

the unit, use the Remote by pressing the appropriate directional 

arrow until the unit is where you can grasp the handle more 

conveniently.

•  Holding the handle ofthe unit, move the switch to the OFF position, 

to the far left, and place finger in the Air Release slot and lifting  

with your finger, you will release the vacuum from the inner 

circle. In a few seconds, the unit will be free from the window.

•  If you do NOT use the Air Release button, you need to hold the 

handle for about 45 to 60 seconds. Do NOT try to use the handle 

as leverage to pry the unit from the window as you could damage 

the product.

•  After removing the unit from the window, do the required  

maintenance on the product in preparation for storage. BEFORE 

storing, while the unit is plugged into your receptacle, move  

the switch to the Charge position and allow the battery to charge 

until the Green light quits Flashing.

•  Always Store the unit with the switch in the OFF position.

4.5 Product Restart

 •   When the product cycles a place repeatedly during the operation, 

or stops working, sending a warning prompt and the red indicator 

light flashing, grasp the unit bythe handle and turn the switch to 

the OFF position. Then, turn the unit back ON and press the 

Pause/Start button on the unit to continue the cleaning process.