ECOVACS WINBOT Instruction Manual - page 90

ENG - 90

8)  What if Winbot encounters frame ob-

structions?

Under normal circumstances, Winbot will 

automatically maneuver around the  

obstruction and continue its cleaning.

9)  Why does the product fail to completely 

clean the door or window glass?

a.  The front pad could be dirty from cleaning  

the glass and as a result is leaving 

a residue on the glass. Stop and replace 

the pad with a clean pad.

b.  The rear pad may be dirty or contain 

some debris that is leaving marks on  

the glass. You should replace the rear 

pad with a clean pad.

c.  Check that the treads are clean. They 

may also contain some matter that will 

leave marks on the glass that the rear 

pad can not wipe off. The treads should 

be checked often for cleanliness and 

wiped with a damp cloth.

d.  The provided cleaning solution should 

be used when cleaning the glass. When 

you deplete liquid cleaning solution, you 

can replace it by similar window cleaner 

or purchase a new special window 

cleaning liquid solution from Ecovacs. 

A dry cloth will only wipe dust and NOT 

clean the glass.

e.  Winbot cannot clean paint, stains, paper, 

or glue from the window. You will have 

to continue removing these residues by 

hand as you have done previously.

10) How to completely clean the door or 

window glass?

Winbot cannot clean paint, stains, paper, 

or glue from the window. You will have to 

continue removing these residues by hand 

as you have done previously.

11) How to store the product when not in 

use?

The product must be cleaned and with  

the switch in the OFF position. lt needs to 

be stored in a dry place away from heat 

and strong sun light which can have  

a detrimental affect on the unit.

12) When the product cleans the outside 

of the window and the alarm goes off, 

I may not be able to hear the alarm?

Winbot has a feature that will visually let 

you know if a problem occurs while also 

sounding its alarm. The Indicator light on 

the bottom ofthe unit will flash red, letting 

you know there is a problem that requires 

your attention.

13) When the product gets into trouble, 

such as stopping in a place on the window 

or in the corners,what do I do?

The product may get into trouble when 

cleaning the door and window glass. In 

such cases, it will try to get out of trouble; 

if it fails, your assistance will be needed. 

First, press RESET button to restart the 

product and the product should start clean-

ing again.

14) Can Winbot completely clean the cor-

ners of the window glass?

Winbot is programmed to clean the windows 

as good and efficiently as possible. There 

may be some circumstances that corners 

may not be totally cleaned. With the Remote, 

you can take control of Winbotwhen it has 

finished cleaning the window and drive it to 

those spots that need to be attended to  

We feel that this will satisfactorily resolve 

your problém.

Should you still encounter some situations 

that have not been properly addressed to 

your satisfaction, we ask that you contact 

our Service Department where a Technician 

can properly address your specific problem 

or question. Or call our service number.