ECOVACS WINBOT Instruction Manual - page 81

Enjoy smarter life

ENG - 81

ENG

4. USE OF PRODUCT

WARNING

If Winbot is used to clean a window above ground level, the Safety Pod MUST be used.

Winbot must be used in strict accordance with the directions in the Instruction Manual. 

ECOVACS is not responsible for any damages due to improper use.

Note: Before operation ofthe unit, you must carefully read the content of “Safety Introductions” 

before using the product. Any operation inconsistent with the contents of Instruction Manual may 

cause damage to the product or cause personal injury.

4.1 Placement of Winbot

• Make sure that there is enought power cord for the WINBOT to 

clean the entire window without restricting its movement. If there 

is not enough cord, it is not safe to use the WINBOT on that 

particular window until a WINBOT Extension Cord is attached.

• Loop one end of the Safety Rope around the Safety pod´s 

channel and pull it tight.

• Loop the other end of the Safety Rope to the power connector on 

the power cord and tighten.

• If an Extension Cord is attached, the Safety Rope must be tied to 

the power connector on the Extension Cord. Note: Do NOT attach 

the Safety Rope to the thin part of the cord.

• Press the Safety Pod suction cup FIRMLY in the lower corner on 

the opposite side of the glass you are cleaning. Make sure the 

Safety Pod suction cup is securely in place.

• Make sure the button on the bottom ofthe Winbot is turned ON.

• Plugging the Adapter into your receptacle and push the power 

button to start Winbot.

• Spray the front Pad with the provided Window Cleaning Solution 

lightly. After having cleaned your windows a number oftimes, you 

will begin to know how damp the Pad should be to clean your 

windows. If you get the Pad too Wet, it may not allow the treads to 

properly drive the unit on the window. Do NOT spray the back pad 

as this Pad is for wiping the window after the treads.

• With the unit placed horizontally on the window and about 10 cm 

from the corners of the lower window, move the switch to the 

ON position and only let go once the unit has securely attached 

itself to the window being indicated by the Indicator Light flashing 

BLUE in color. At this point, you should remove your hand from 

the unit.When Indicator Light do NOT light, it means the suction 

power in too small. Please check or replace the cupule. When 

Indicator Light flashes red, please adjust the height of placement 

and restart the product.

•  With the Safety Pod attached to the inside of the window, close 

the window without damaging the outer skin of the Supply Cord. 

Make sure there is enough cord between the Safety Pod and the 

Winbot for the unit to clean the entire window without restricting 

its movement.