EcoWater ECR 3500R20 Owner's Manual - page 10
10
CONNECTING TO REMOTE
When the softener’s electronic control is first powered
up, it is not yet in communication with the remote. Do
the following to establish a link between the two:
1. This procedure involves pushing buttons on both the
softener and remote, so have the remote near the
softener for now. Make sure the remote is powered
up (See “Installing Batteries” on Page 22).
2. From any of the rolling status screens, press the soft-
ener’s SELECT (
) button to display the Main
menu.
3. Press the softener’s DOWN (
) button to scroll
through the menu options until Advanced settings is
highlighted (See Figure 17).
4. Press the softener’s SELECT (
) button to display
the Advanced settings menu (See Figure 18).
FIG. 17
FIG. 18
5. Press the softener’s DOWN (
) button to scroll
through the menu options until Connect to remote is
highlighted.
6. If the remote does not already show a menu screen,
press the remote’s SELECT (
) button to display a
Menu screen. (See Figure 95 on Page 24).
7. Press the remote’s DOWN (
) button to scroll
through the menu options until Add new device is
highlighted in a box (See Figure 96).
8. Press the remote’s SELECT (
) button, and the
“Waiting for new device...” screen appears (See
Figure 97). The remote waits two minutes for the
softener to be activated (in the next step).
9. Make sure the softener’s display still shows the
screen in Figure 18. Press the softener’s SELECT
(
) button to display the “Looking for remote” screen
(See Figure 19).
continued
FIG. 19
10. Within a few seconds the screen should change to
show “Remote found” (See Figure 20). If, after
about one minute, the softener’s screen instead
reads “New remote not found,” press the softener’s
SELECT (
) button to return to the screen in Figure
18 and press the remote’s LEFT (
) button to
return to the screen in Figure 96. Then repeat this
procedure from Step 8. If the remote is not found
after several tries, contact your dealer for service.
Take note of the message on the remote’s screen
after an unsuccessful attempt, as it indicates the
nature of the problem.
FIG. 20
11. Press the softener’s SELECT (
) button. The dis-
play will go back to the Advanced settings menu
(Figure 18).
12. Press the softener’s LEFT (
) button twice to
return to the rolling status screens.
FIG. 21
FIG. 22
LONG DISPLAY SCREEN MESSAGES
Most messages in the softener’s display screens are
short enough to be shown as a single line. Longer
messages will be truncated (See Figure 21 for an
example) until you highlight them.
ECOWATER
S Y S T E M S
Conditioner Operation
One second after being highlighted, the viewing box
expands (See Figure 22) to show the entire message.
After three seconds the view resets (Figure 21).