EcoWater ECR 3500R20 Owner's Manual - page 13
SETTING RECHARGE TIME
When the softener’s electronic control is first powered
up, the default time for starting an automatic recharge is
2:00 a.m. This is a good time in most households
because water is not being used. To change this time:
1. From any of the rolling status screens, press the
SELECT (
) button to display the Main menu.
2. Press the DOWN (
) button to scroll through the
menu options until Basic settings is highlighted
(See Figure 34).
FIG. 35
3. Press the SELECT (
) button to display the Basic
settings menu (See Figure 35).
FIG. 36
FIG. 34
4. Press the DOWN (
) button to scroll through the
menu options until Recharge time is highlighted.
5. Press the SELECT (
) button to display the
Recharge time screen (See Figure 36).
6. Press the UP (
) or DOWN () buttons to change
the recharge time in 1 hour increments. Hold the
button down to rapidly advance. Be sure that AM or
PM is correct (unless softener is set for a 24-hour
clock).
7. Press the SELECT (
) button. The display will go
back to the Basic settings menu (Figure 35).
8. Press the LEFT (
) button twice to return to the
rolling status screens.
7. Press the SELECT (
) button. The display will go
back to the Basic settings menu.
8. Press the LEFT (
) button twice to return to the
rolling status screens.
SETTING IRON LEVEL
When the softener’s electronic control is first powered
up, a “wizard” screen prompts you to enter your water’s
iron level (See Page 8). The conversion factor is 3
grains per ppm of clear water iron. To change:
1-3. Go to the Basic settings menu by following Steps
1-3 in “Setting Recharge Time” at left.
4. Press the DOWN (
) button to scroll through the
menu options until Iron level is highlighted.
5. Press the SELECT (
) button to display the Iron
level screen (See Figure 38).
FIG. 38
6. Press the UP (
) or DOWN () buttons to set the
value for iron in your water. Hold the button down to
rapidly advance.
7. Press the SELECT (
) button. The display will go
back to the Basic settings menu.
8. Press the LEFT (
) button twice to return to the
rolling status screens.
SETTING HARDNESS
When the softener’s electronic control is first powered
up, a “wizard” screen prompts you to enter your water’s
hardness (See Page 8). To change it:
1-3. Go to the Basic settings menu by following Steps
1-3 in “Setting Recharge Time” at left.
4. Press the DOWN (
) button to scroll through the
menu options until Hardness is highlighted.
5. Press the SELECT (
) button to display the
Hardness screen (See Figure 37).
FIG. 37
13
ECOWATER
S Y S T E M S
Conditioner Operation
NOTE: Do not increase the hardness setting to
compensate for iron in your water. The
electronic control compensates automatically
after you set the iron level, below.
6. Press the UP (
) or DOWN () buttons to set the
value for your water’s hardness. Hold the button
down to rapidly advance.