EcoWater ECR 3500R20 Owner's Manual - page 24
24
Alert
TM
FIG. 94
Display
LEFT
Button
RIGHT
Button
UP
Button
DOWN
Button
Alert
LED
SELECT
Button
ADDING A DEVICE
To initiate communication between the remote and a
device such as a water softener, it is necessary to add
the device to the remote by doing the following:
1. If no device has been added to the remote, the menu
shown in Figure 95 is displayed instead of status
screens. In this case, skip to step 2. Otherwise, if
status screens are shown, press the remote’s
SELECT (
) button to display a Menu screen (See
Figure 95).
2. Press the DOWN (
) button to scroll through the
menu options until Add new device is highlighted in
a box (See Figure 96).
3. Press the SELECT (
) button, and the screen shown
in Figure 97 appears. The remote waits two minutes
for the device to be activated (following the instruc-
tions in that device’s manual). For complete instruc-
tions on adding the softener, refer to “Connecting to
Remote” on Page 10 of this manual.
4. When the remote detects a signal from the device,
the display will change to show that it has been
added to the remote (See Figure 98). If another
message appears instead, indicating the device was
not added successfully, press the LEFT (
) button to
return to the screen in Figure 96. Repeat Step 3. If
this does not work, contact your dealer for service.
FIG. 95
FIG. 96
FIG. 97
FIG. 98
5. To exit this screen, press the LEFT (
) button or wait
30 seconds for it to exit automatically.
REMOTE MENUS
Startup Menu
Before any devices have been added to the remote, the
following menu is displayed:
Display options
Set language (See Page 26)
Network options
Add new device (See Page 24)
Softener Menu
After the softener has been added, the remote will dis-
play a softener status screen as one of the rolling status
screens. Pressing the remote’s SELECT (
) button
when the softener status screen is displayed shows the
following menu:
Remote Control
Recharge (See Page 27)
Recharge time (See Page 27)
Display options
Display data (See Page 28)
Display order (See Page 29)
Remote control data (See Page 29)
Rename device (See Page 30)
Set language (See Page 26)
Network options
Add new device (See Page 24)
Delete current device (See Page 30)
RF signal strength (See Page 25)
Drinking Water Status Menu
If no drinking water system has been added, the remote
will display a drinking water status screen as one of the
rolling status screens. Pressing the remote’s SELECT
(
) button when the drinking water status screen is dis-
played shows the following menu:
Display options
Drinking water message (See Page 26)
Set language (See Page 26)
Network options
Add new device (See Page 24)
ECOWATER
S Y S T E M S
Remote Operation
Photo
Cell