EcoWater ECR 3500R20 Owner's Manual - page 26
26
SETTING THE LANGUAGE
Language is set independently on the remote and sof-
tener (See Page 14 to set the softener’s language).
Fewer languages are available on the remote. To
change the remote’s language:
1. Press the remote’s SELECT (
) button to display a
Menu screen.
2. Press the DOWN (
) button to scroll through the
menu options until Set language is highlighted in a
box (See Figure 102). Press the SELECT (
) button.
5. Press the DOWN (
) or UP () buttons to scroll
through the list to the desired language, then press
SELECT (
) to choose it.
6. Press the SELECT (
) button. The display will go
back to the menu shown in Figure 102, in the newly
set language.
7. To exit this menu, press the LEFT (
) button or wait
30 seconds for it to exit automatically.
FIG. 102
FIG. 103
ECOWATER
S Y S T E M S
Remote Operation
TO SET THE REMOTE TO ENGLISH
IF ANOTHER LANGUAGE IS DISPLAYED:
From the rolling status screens, press SELECT (
).
Press DOWN (
) to scroll through the list until the
line immediately above the antenna ( ) symbol
is highlighted (See Figure 104), then press
SELECT (
). Press UP () to scroll to English at
the top of the list, then press SELECT (
) twice.
Press LEFT (
) to exit the menu.
3. Depending on which devices are added, you could
see a message saying “This will delete all devices!
Continue?” If so, you would need to add the devices
again after changing the language. Press the RIGHT
(
) button to continue (or skip to Step 4 if this mes-
sage is not displayed).
4. The Set language menu is displayed (See Figure
103). The current language has a black dot next to it.
FIG. 104
DRINKING WATER STATUS MESSAGE
If a communications-capable drinking water filtration
(RO) system has been added to the remote, it will have
its own status screen displayed during normal opera-
tion. Otherwise, a drinking water status screen will dis-
play a message like the one shown in Figure 105.
If the message displayed is not appropriate to your sys-
tem, change it as follows:
1. Press the remote’s LEFT (
) or RIGHT () buttons
to manually advance to the Drinking water status
screen (See Figure 105).
4. Press the SELECT (
) button to display the Drinking
water message menu (See Figure 107).
5. The current message has a black dot next to it.
Press the DOWN (
) or UP () buttons to scroll
between the two messages, then press SELECT (
)
to choose one.
6. Press the SELECT (
) button. The display will go
back to the menu shown in Figure 106.
7. Press the LEFT (
) button to exit this menu, or wait
30 seconds for it to exit automatically.
FIG. 106
FIG. 107
FIG. 105
2. Press the remote’s SELECT (
) button to display the
drinking water status menu (See Figure 106).
3. If necessary, press the DOWN (
) button to scroll
through the menu options until Drinking water mes-
sage is highlighted in a box (See Figure 106).