EDAN SONOTRAX Basic User Manual - 2.5 Socket
SONOTRAX Series Ultrasonic Pocket Doppler User Manual Doppler and Accessories
- 8 -
2.5 Socket
The two sockets are located on the top panel of the Doppler.
(1) Earphone socket
: the earphone or line-in cable connects to the Doppler via this socket.
Figure 2-6 Line-in Cable
Signal Interface
1 GND 2 Signal
3 Signal 4 Signal
5 Signal
(2) Charge socket
: the special lithium-ion polymer battery charger connects to the
Doppler via this socket.
(For SONOTRAX II and SONOTRAX II Pro
only)
NOTE:
Accessory equipment connected to the analog and digital interfaces must be certified
according to the respective IEC/EN standards (e.g. IEC/EN 60950 for data processing
equipment and IEC/EN 60601-1 for medical equipment). Furthermore all configurations
shall comply with the valid version of the system standard IEC/EN 60601-1-1. Anybody
who connects additional equipment to the signal input connector or signal output
connector to configure a medical system must ensure that the system complies with the
requirements of the valid version of the system standard IEC/EN 60601-1-1. If in doubt,
consult our technical service department or your local distributor.
2
1
3
4
5