EDAN SONOTRAX Basic User Manual - page 25

SONOTRAX Series Ultrasonic Pocket Doppler User Manual                              Operation 

- 20 - 

Figure 3-9 Sound Recorder                     Figure 3-10 Recording 

Click on the start key 

  to start recording, refer to figure 3-9.   

You can record 60 seconds each time. When the time is up, click on the start key again to keep on 

recording. 

Click on the stop key 

  to stop recording, refer to figure 3-10. 

Click on File > Save, input the file name, select a folder and click on Save to save the signals in a 

“.wav” file. 

To start a new recording, click on File > New. 

3.8.2 Playing Sound Files 

The recorded sounds are saved as waveform (.wav) files in your computer. 

You can play the waveform file with the sound recorder. Run the sound recorder, click on File > 

Open, search for the folder and select the file, click on Open to load the file, and then click on 

the play key 

. 

If you have any other program that supports waveform (.wav) files installed on your PC, 

double-click on the file to play it. 

3.8.3 Burning CD or Sending in Email 

The waveform files saved in your PC are normal audio data files. You can burn them into CDs or 

e-mail to whomever you want. 

3.8.4 Record Troubleshooting 

If there is audio output from the speaker or earphone, but the PC recorder does not have any input. 

(The green line recording area has no waveform.) The reason could be: 

1. Poor connection of the audio cable between the Doppler and the PC.   

- Check the plugs of the cable and re-connect it if any poor connection is detected. 

2. The audio cable has been plugged to the wrong socket of the PC, instead of the audio input