EDAN SONOTRAX Basic User Manual - Chapter 3 Operation
SONOTRAX Series Ultrasonic Pocket Doppler User Manual Operation
- 12 -
Chapter 3 Operation
NOTE:
To ensure that the Doppler works properly, please read this chapter and
Chapter 1
Safety Guide before operation; follow the steps when connecting all the components.
3.1 Opening the Package and Checking
Open the package; take out the Doppler and accessories carefully. Keep the package for possible
future transportation or storage. Check the components according to the packing list.
Check for any mechanical damage.
Check all the cables and accessories.
If there is any problem, contact us or your local distributor immediately.
3.2 Installing/Replacing Battery
To install or replace a battery, perform the following steps:
1) Open the battery compartment.
Turn the Doppler upside down. Press the two stripe marks on the battery compartment cover with
your thumbs respectively. Slide the cover in the direction of the arrow with mild force to open the
compartment.
Figure 3-1 Opening battery compartment
2) Install / Replace the battery.
Remove the old battery from the connector if necessary.
NOTE:
Do not use excessive force when disconnecting the battery and the connector, in case
the connector falls off.
Connect the new battery to the battery connector, and then put the assembly into the battery
compartment. (Figure 3-2 a)