Faroudja DVP2200 Installation And Operation Manual - page 5
4
Unpacking
Remove the DVP2200 unit from the shipping
container and examine it for any signs of
shipping damage or missing items (check
inventory list below). All shipping materials
should be saved if the unit is to be moved or
returned for service.
Installation
The DVP2200 processor is designed to be
placed on a table or rack mounted. If the rack
mounting installation kit is to be used, the rack
mount ears are mounted by using 3 screws. It
will be necessary to support the rear of the unit if
it will be shipped in the rack by using rack
support rails supplied by the rack manufacturer.
Ventilation
To reduce noise, the unit has been designed to
operate properly without a fan. The unit is cooled
by convection. As the heat rises out of the vents
on the top of the unit, cool air is drawn in frm the
bottom. These vents must not be blocked.
When rack mounted, a minimum of 1.25" (1 rack
unit height) of free space is required above and
below the unit to allow for proper cooling. A force
air fan should be added to the rack installation if
power amps are located in the same air space.
Rear Panel I/O
Inputs
1. S-Video (4 Pin DIN)
2. Composite Video (RCA)
3. Component Video (RCA)
4. HDTV/Computer (D15M)
Outputs
5. RGBHV or YPrPb (D15F)
6. RGBHV or YPrPb(BNC)
7. 12V Trigger (3.5mm Mini-Jack , 2or 3pin)
8. 5V (3.5mm Mini-Jack , 3pin)
9. RS232 Port (D9F)
10. Power
Installation
1
2
3
4
5
6
7
8
9
10
Inventory
1 – DVP2200
1 - Remote
1 – Owner’s Manual
2 – Rack Mount Ears
1 – Power Cord
1 – Warranty Card