Faroudja DVP2200 Installation And Operation Manual - page 9
8
Front Panel Controls
1. Power/Standby: Press to turn the unit On
(Green) or to Standby (Red)
2. Infrared Sensor window
3. Function + /- : Cycles up or down through
the available control Functions
4. Value +/- : Adjusts the levels or changes
settings of the Function selected.
5. Factory Preset: Recalls all settings to
Factory levels
6. LCD Display: Provides readout of all
Functions and Values.
Note: When Functions are accessed via the
front panel controls no On-Screen-Displays
are visible.
Operation
There are three ways to control the unit; from the
front panel, from the remote control and via
RS232. Controlling from the front panel requires
cycling through the available functions.
Controlling from the remote can be either by
cycling through the functions or by direct
accessing each function.
The available control functions are listed below in
the order they appear on screen:
Input
Video – S-Video – YCrCb - HDTV
Preset
Factory –
Preset 1 – Preset 2 – Preset 3 – Preset 4
Aspect Ratio
(Only available with 16:9 screens. See
Setup)
Anamorphic– Letterbox - 4:3
Brightness:
0– 255 Preset @128
Contrast:
0– 255 Preset @175
Color:
0– 255 Preset @128
Tint:
0– 255 Preset @128
Detail:
0-15 Preset @ 5
Noise
Reduction:
0-15 Preset @ 10
Store User Preset: See
Storing Preset Section
Setup: See
Setup section
Operating Instructions
1
2
3
4
5
6