Fastrax IV Instruction Manual - page 37

31 

There are 8 levels of priority. The function can be selected by Preset, Auto scan, Pattern or 

Tour and “0” is the highest priority. Lower priority alarms won’t be serviced until the higher 

priority alarm is completed. Equal priority alarms will be serviced repeatedly with the dwell 

time. 

3.10 Schedule 

You can set the schedule of Preset, Pattern, Tour, Auto Scan, Auto Pan, Origin, DIS On, DIS 

Off on this menu.  

Selected Function will be effective per selected start time and day (of the week) range. 

Follow below steps to set schedule. 

1. Locate cursor on the “+” and then, twist Joystick (keyboard) to add a new schedule. 

2. To choose day (of the week) range, locate cursor on the relevant “Day” and then twist 

Joystick (keyboard) to set one of 10 ranges.  

    (All, Mon, Tue, Wed, Thu, Fri, Sat, Sun, S-S, M-F) 

3. To choose start time, locate cursor on the relevant “Start time” and then twist Joystick 

(keyboard) to set time. 

4. Choose one function to work on this schedule. 

Note : In prior of this setting, the functions need to be set on menu. 

Enable 

Choose to enable or disable selected function. 

X 

Delete the relevant schedule. 

<  

Return to the previous page in the schedule list. 

>  

Return to the next page in the schedule list. 

Note : Origin check in Schedule will not be activated when the camera is operating 

under Auto Scan, Pattern, Tour and Event function per other schedule.