Fastrax IV Instruction Manual - 2. Description

71 

2. DESCRIPTION 

The Indoor/Outdoor dome housing is used with dome camera. The housing is constructed of 

aluminum, steel and plastic. The housing is designed to be mounted on both the wall and the  

ceiling. The housing meets international IP66 standards for dust and moisture resistance.  

Sunshield model is available for application to avoid the direct rays of the sun. 

3. INSTALLATION 

Refer to the pages of 6. PARTS LIST. 

1. Attach a mounting base on the ceiling or the  

   wall using tapping screws (Ceiling Mount : M6,  

   Wall Mount : M8, Power Box : M6) and plastic  

   bushings. 

CAUTION :  

   For safety, the structure that a mounting base is  

   installed on should be strong enough to support  

   a minimum of 25kg (55.1 lb). 

   For safety, a mounting base should be strong  

   enough to support a minimum of 19.8lb (9kg). 

2. Wind Teflon Tape around the thread of "A" (Figure 1.)  

about 20 times for seal.  

3. Pull out all the required cables through a mounting base and its pipe.    

4. Fit "A" that Teflon Tape is wound around to the base and turn this unit until it is securely  

fastened. 

5. Connect the power connector of 24VAC of the cables to "AC IN" of fan & heater board 

○

23  . 

6. Connect the power, the Alarm and the communication lines in the cables to the connectors  

of the Base Board of the Dome Camera. 

7. Fasten the Dome Base on the Screw Spacer 

○

18  using 3 screw(BH M4xL8) 

8. Attach the Dome Body to the Dome Base. After aligning the arrow mark of the Dome Base  

with the unlock mark of the Dome Body, turn the Dome Body to the lock mark direction. 

Note : It is recommended to remove the Window and the Bubble Ring Ass'y of the  

          Dome Camera to improve the quality of picture. (Refer to the Figure. 2) 

9. Insert the Rubber Gasket  

○

7   into the Body  

○

6  and fasten the Bubble Ring 

○

11  to the 

Body  

○

6   using  3  screws 

○

13  .