Federal Signal Corporation AR2000-M Installation And Maintenance Manual - page 3
-2-
ZONE 1
PRESET 1
CH B
CH A
MICROPHONE
AUX SPEAKER
PHONE
AR2000-M
ALL CANCEL
ALL CALL
CORPORATION
UNIVERSITY PARK, IL U.S.A.
R
FEDERAL
SIGNAL
PRESET 7
PRESET 4
ZONE 4
ZONE 2
ZONE 3
PRESET 2 PRESET 3
ZONE 5
ZONE 6
ZONE 7
PRESET 6
PRESET 5
POWER
ZONE 8
ALARM
PRESET 8
290A4120-01
Figure 1-1.
ZONE 2
AR2000-Z
UNIVERSITY PARK, IL U.S.A.
CORPORATION
FEDERAL
SIGNAL
R
ZONE 1
ZONE 5
ZONE 4
ZONE 3
ZONE 7
ZONE 6
ZONE 8
POWER
290A4120-02
Figure 1-2.
Each preset can be manually activated locally with
its associated push button switch on the front panel or
with a contact closure at the associated preset control
inputonthebackpanel.Wheneverapresetisactivated,
either locally or remotely, its associated front panel push
buttonLEDilluminatestoindicatethatthepresethas
beenactivated.TheLEDremainslituntilthepresetis
deactivated or the remote contact closure is removed. As
an added feature, when a preset is remotely activated,
theassociatedLEDilluminatesandflashesuntilthe
remotecontactclosureisremoved.AllAR2000-M
controls are located on the front panel except gain
adjustmentswhicharemadeonthebackpanelduring
installation.
Operation (normal mode)
PressingtheChannelAorChannelBbuttonwill
immediatelyswitchtheinputtothatchannel;thespeaker
indicatorlightswillindicatewhatspeakersareconnected.
Pushingaspeakerbuttonwillturnthatspeakeronor
off;pushingapresetbuttonwillselectspeakersper
thatpreset,andmayalsoselectChannelAorB(ifthat
presetwasconfiguredforaspecificchannel).Keyingthe
microphone while in this mode will cause the microphone
signaltobesenttotheselectedspeakers;releasing
themicrophonewillallowChannelAorBoperationto
resume.
KeyingtheMicrophonebuttonwillallowtheuserto
directaudiotospecificzones(defaultisAll-Call).Theuser
mayselectzonesusingeitherindividualspeakerorpreset
buttons;ChannelAorBoperationwillnotbeinterrupted
untilthemicrophoneisactuallykeyed.Releasing
themicrophonewillallowChannelAorBtoresume
operationonitsselectedspeakers.
Pressing the All Call button (whether the unit is in
MicrophonemodeorChannelA/Bmode)willcauseall
zones to be selected. Pressing any individual zone when All
Call is lit, however, will cancel all the zones except that one.
Pressing All Call will perform the following function:
If all of the zones are not selected, “All Call” will
select all 64 zones. Otherwise, pressing “All Call” will
cancel all of the zones.
Telephone operation
When the line attached to the Router is called,
therouterwillanswerwiththeMessage“ENTER
PASSWORD”.Thecallerisrequiredtoentertheir8digit
password.Thecallerisgiven2chancestoenterthe
correct password.
If the correct password is not entered, the caller
hearsthemessage“GOODBYE”andthesystemhangs
up the phone line.
If the correct password is entered the caller will
hearthemessage“PRESS9KEYTOCHANGETHE
PASSWORDOR6KEYTORECORDAMESSAGE”.
Ifthecallerpressesthe9key,themessage“ENTER
NEWPASSWORD”willinformthecallertoenteranew
password.Thesamenewpasswordmustbeentered
twice. Otherwise, the caller will hear the message
“PASSWORDNOTCHANGED”thenthemessage
“GOODBYE”andthesystemhangsupthephoneline.If
the new password is successfully entered twice, the caller
willhearthemessage“PASSWORDCHANGED”then
themessage“GOODBYE”andthesystemhangsupthe
phone line.