Ferimex E-4000 User Manual - page 10
Changes to access/verify parameters are applied only after executing the command:
reload ac[cess]
To show the interface settings use the command:
show
Example:
manager$ show eth0
ipaddr: 195.168.233.65
netmask: 255.255.255.252
access: all(2)
verify: no(0)
Working with multiple IP address for an interface
Every interface could have more than one IP address defined. The additional addres-
ses are called aliases. Every alias is represented with notation
To set an alias on eth0, simply issue the following command:
set eth0:1 ip 241.100.10.1/30
reload net
Note, that aliases could not overlap, i.e. each alias has to be in its own network.
To delete the alias, use the del command, e.g.:
del eth0:1
To display the current settings use:
manager$ show eth0:1
ipaddr: 141.100.10.1
netmask: 255.255.255.252
Note: access and verify parameters are not displayed or accepted, because they are
relevant only to the main interface.
To list ip parameters of all interfaces, use the command:
sh[ow] if
To list ip parameters for a specific type of interfaces, use the command:
sh[ow] eth|br (note missing interface number)
11
TRAFFIC MANAGER E-4000