Ferimex E-4000 User Manual - page 9
set
set
set
set
set
show (if|eth|br)[:] # lists interfaces with configured IP address
add
del
-
-
195.168.233.65
-
1. decimal dotted notation, e.g.: 255.255.255.252
2. abbreviated form, representing number of 1’s in binary representation:
255.255.255.252=11111111.11111111.11111111.11111100
thus, number of 1’s is 30
Example:
set eth0 ip 195.168.233.65/255.255.255.252
or abbreviated form:
set eth0 ip 195.168.233.65/30
1’s
32
30
29
28
27
26
25
24
Mask
255
252
248
240
224
192
128
0
set
- none – no access is allowed
- all – no access restrictions
- listed – allow only stations that correspond to enabled classes
with their MAC address defined. On ethernet interfaces the
restriction is implemented in software, thus only communicati-
on with the Traffic Manager is restricted, communication bet-
ween stations on the segment is not influenced.
verify
- 0|no|false|off – no verification of valid IP addresses is done
- 1|yes|true|on – allows communication only with stations that
correspond to classes with defined MAC and IP address. class
enable is taken into account only if access=listed.
Changes are applied only after executing the command:
reload net[work]
10
TRAFFIC MANAGER E-4000