Ferimex E-4000 User Manual - page 22
load|save config|cfg
set config|cfg default # restores the default cfg
# reload cfg is needed to make the load cfg effective
save config
plain textfile that has the same syntax as given in command line, so it could be
cut&pasted into the console.
load config
set config default restores the configuration to the default settings.
reload config is needed to apply the loaded config.
Upgrading the device firmware
Once download parameters are set (see above), you can download and upgrade devi-
ce firmware.
show ver[sion]
load firmware|fw
# command reboot is needed to make the load fw effective
show ver displays the current running version number.
Full firmware filename is of the form tm-
reviated form:
load fw 2.1.1
so, the the tm- prefix and -
load firmware
will be executed after the command reboot (note. it is NOT enough to make the hard-
ware reboot).
This documentation describes the firmware version 2.1.1.
New firmware images are available upon request at:
Ferimex IT spol s r.o.
Výtvarná 8
Bratislava
officeba@ferimexit.sk
23
TRAFFIC MANAGER E-4000