Ferimex E-4000 User Manual - page 19
ing hardware and might not work in some models.
show sys[tem] date|time
Displays the current day and time.
set sys[tem] date|time
Use this command to set the time and date. If
is retrieved via UDP port ntp(123). If
ntp.nasa.gov.
show
ver[sion]
show
sys[tem] ver[sion]
Displays the current firmware version.
show
sys[tem] up[time]
Displays how long time has elapsed since the deviced booted.
set
sys[tem] [host]name
Use this command to set the hostname of the Traffic Manager to the
hostname is always shown at the prompt. The value will get applied after reboot.
arp command
Syntax:
arp [-a]
arp –s
arp –d
arp command without argument shows the current arp table. It contains all the hosts
and their hardware MAC addresses that are communicating with the Traffic Manager.
It might be useful to check the association between IP and MAC address in case you
are not using parameter verify=1 on the given interface. Note that arp entries are valid
only a short time and get periodically refreshed for validity.
The second and third form allow to set and delete arp entries.
20
TRAFFIC MANAGER E-4000