Ferimex E-4000 User Manual - page 18
SNMP configuration
Traffic Manager supports configuration over SNMP. To set up SNMP parameters, you
can use following commands:
set sn[mp]
show sn[mp] [
del sn[mp]
add|set sn[mp]
reload snmp
snmpparam:
loc[ation]
string describing device location
con[tact]
email address of the device admin
stat_period|sp
specifies how often are accounting stats updated
snmp-multi-param:
ro_ip
range of IP adresses that can be used to access the devi-
ce in read-only mode.
ro_comm
community – string used for verifying access to the
SNMP for read-only users.
rw_ip
range of IP adresses that can be used to access the devi-
ce in read-write mode. You can set multiple ranges
rw_comm
community – string used for verifying access to the
SNMP for read-write users.
All the changes get effective only after reload snmp.
All those multi params allow multiple values to be set.
Example:
set snmp ro_ip1 10.10.10.10
set snmp ro_comm1 public
set snmp ro_ip2 10.10.11.10
set snmp ro_comm1 public
Another way to add the following number in a range is:
add snmp rw_ip 192.168.1.1
add snmp rw_comm admin
Miscellaneous admin commands
Syntax:
show sys[tem] temp[erature]
Displays the ambient and CPU temperature. This feature is dependent on the underly-
19
TRAFFIC MANAGER E-4000